1.CHECK TAIL LIGHT POWER SUPPLY CIRCUIT (SHORT)
- Ignition switch OFF
- Disconnect the following connectors.
- IPDM E/R
- Front combination light LH
- Front combination light RH
- Rear combination light LH (body side)
- Rear combination light RH (body side)
- Rear combination light LH (power liftgate side)
- Rear combination light RH (power liftgate side)
- License plate light LH
- License plate light RH
- Check continuity between IPDM E/R harness connector and ground.
IPDM E/R | — | Continuity |
Connector | Terminal |
E119 | 4 | Ground | Not existed |
17 |
Is the inspection result normal?
Repair or replace harness.
2.CHECK TAIL LIGHT POWER SUPPLY
- Connect IPDM E/R connector.
- Ignition switch ON
- With operating the lighting switch, check the voltage between rear combination light (body side) harness connector and ground.
+ | - | Condition | Voltage |
Rear combination light (body side) |
Connector | Terminal |
RH | B102 | 2 | Ground | Lighting switch | 1ST | 6 – 16 V |
OFF or AUTO* | 0 – 1 V |
LH | B90 | 1ST | 6 – 16 V |
OFF or AUTO* | 0 – 1 V |
*: Only when the illumination judgement by intelligent auto light system is OFF.
Is the inspection result normal?
.
4.CHECK LICENSE PLATE LIGHT
5.CHECK FRONT SIDE MARKER LIGHT
6.CHECK REAR SIDE MARKER LIGHT