[Previous][Next]
REMOVAL AND INSTALLATION
 
 
warningFor removal and installation of the Knee air bag module (driver's side), always observe the service procedures described in SRS Airbag, Knee Air Bag Module (Driver's Side).
Air mixing damper control motor (driver's side) removal steps
Knee air bag module (driver's side) (Refer to Removal and Installation).
1.Air mixing damper control motor (driver's side)
TCU (Refer to Removal & Installation).
2.Air mixing damper control motor (passenger's side)
Mode selection damper control motor removal steps
TCU (Refer to Removal & Installation).
3.Mode selection damper control motor
Outside/inside air selection damper control motor removal steps
Globe box assembly (Refer to Removal and Installation).
4.Outside/inside air selection damper control motor
Air mixing damper control motor (rear) removal steps
Instrument lower center panel (Refer to Removal and Installation).
Floor console panel (Refer to Removal and Installation).
5.Air mixing damper control motor (rear)

 
 
REMOVAL SERVICE POINT
 
 
<<A>> MODE SELECTION DAMPER CONTROL MOTOR, OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR REMOVAL
noteA normal plate-type ratchet driver is recommended.