[Previous][Next]
REMOVAL AND INSTALLATION
 
 
The following bolts and screws are used for installing the floor console assembly. Bolts and screws are indicated as marks shown in the illustration in the sections of "Removal and Installation."
NameSymbolSize (D X L) mmColorShape
Tapping screwa5 X 16-
b5 X 12-
Washer assembly boltc6 X 16-
d6 X 20-
D: Thread diameter, L: Effective thread length
 
 
Pre-removal and Post-installation Operation
Removal steps
1.Instrument side panel
•Console finisher assembly (Refer to Removal and Installation)
•Instrument lower center panel (Refer to Removal and Installation)
•Console rear finisher (Refer to Removal and Installation)
•Console Duct (Refer to DUCTS REMOVAL AND INSTALLATION)
•Floor console box cup holder (Refer to Removal and Installation)
2.Cluster lid finisher
•Electric shift selector assembly connecting bolt (Refer to Removal and Installation)
3.Floor console box
4.Center console assembly
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSTRUMENT SIDE PANEL REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<B>> CLUSTER LID FINISHER REMOVAL
<Up to late January, 2022>
1. Slide the seat to the rear of the vehicle.
2. Press the seat surface from the upper diagonal side to expand the clearance between the seat surface and the cluster lid finisher.
3. Remove the three screws on the cluster lid finisher.
4. Disengage the four clips connecting the cluster lid finisher and the floor center console by using ornament remover (Special tool: MB990784).
5.
cautionWhen pulling out the cluster lid finisher upward, be careful not to let the protruding parts get caught as it may damage the cluster lid finisher.
Remove the cluster lid finisher by pulling it out upward.
<From early February, 2022>
1. Slide the seat to the rear of the vehicle.
2. Press the seat surface from the upper diagonal side to expand the clearance between the seat surface and the cluster lid finisher.
3. Remove the two screws on the cluster lid finisher.
4. Disengage the four clips connecting the cluster lid finisher and the floor center console by using ornament remover (Special tool: MB990784).
5.
cautionWhen pulling out the cluster lid finisher upward, be careful not to let the protruding parts get caught as it may damage the cluster lid finisher.
Remove the cluster lid finisher by pulling it out upward.