[Previous][Next]
REMOVAL AND INSTALLATION
 
 
warningFor removal and installation of the driver's side air bag module, passenger's side air bag module, knee air bag module, always observe the service procedures described in SRS Airbag, Driver's Air Bag Module, Passenger's Air Bag Module, Knee Air Bag Module.
cautionDegrease the A/C evaporator drain hose and heater unit by isopropyl alcohol.
Pre-removal and Post-installation Operation
Removal steps
1.Heater piping hose connection
Console duct, Rear heater duct (Refer to DUCTS REMOVAL AND INSTALLATION).
Camera ECU (Refer to Removal and Installation).
SRS-ECU connector
Console bracket (Refer to Removal and Installation).
ADAS control unit 2 (Refer to Removal and Installation).
Electric shift control module
Cowl top extension
2.A/C pipe assembly connection
3.O-ring
4.Front deck crossmember
5.A/C evaporator drain hose
6.A/C unit assembly
 
 
REMOVAL SERVICE POINT
 
 
<<A>> A/C PIPE ASSEMBLY DISCONNECTION
cautionAs the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.
To prevent the entry of dust or other foreign bodies, plug the dismantled hose and the nipples of the expansion valves.