[Previous][Next]
Removal and Installation
 
 
warning
  • Be sure to check precautions and notes by referring to PRECAUTIONS before work.Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
  • Always observe the following items for preventing accidental activation.
    • Before servicing, ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit).
Pre-removal Operation
Turn the ignition switch to the "LOCK" (OFF) position.
 
 
<FRONT DOOR SATELLITE SENSOR>
Front door satellite sensor removal steps
Disconnect the negative (–) battery terminal.
Front door finisher assembly (Refer to Door Finisher REMOVAL AND INSTALLATION)
1.Front door satellite sensor
Front door satellite sensor installation steps
1.Front door satellite sensor
Front door finisher assembly (Refer to Door Finisher REMOVAL AND INSTALLATION)
Connect the negative (–) battery terminal.
Post-installation inspection
 
 
<B-PILLAR SATELLITE SENSOR AND C-PILLAR SATELLITE SENSOR>
B-pillar satellite sensor removal steps
Disconnect the negative (–) battery terminal.
Seat belt pre-tensioner (Refer to Removal and Installation)
1.B-pillar satellite sensor
B-pillar satellite sensor installation steps
1.B-pillar satellite sensor
Seat belt pre-tensioner (Refer to Removal and Installation)
Connect the negative (–) battery terminal.
Post-installation inspection
C-pillar satellite sensor removal steps
Disconnect the negative (–) battery terminal.
Luggage side lower finisher assembly (Refer to Luggage Trim REMOVAL AND INSTALLATION)
2.C-pillar satellite sensor
C-pillar satellite sensor installation steps
2.C-pillar satellite sensor
Luggage side lower finisher assembly (Refer to Luggage Trim REMOVAL AND INSTALLATION)
Connect the negative (–) battery terminal.
Post-installation inspection
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT DOOR SATELLITE SENSOR/B-PILLAR SATELLITE SENSOR/C-PILLAR SATELLITE SENSOR REMOVAL
Disengage front door satellite sensor lock pin according numerical order 1→2 indicated arrows as shown in figure.
caution
  • Never damage front door satellite sensor harness.
  • To prevent damage to the parts, never impact the satellite sensor.
  • Replace satellite sensor if it is dropped or sustains an impact.
  • Replace satellite sensor of deployed front side air bag module, deployed front center air bag module, deployed rear side air bag module and deployed curtain air bag module.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< POST-INSTALLATION INSPECTION
caution
  • After installation is completed, perform self-diagnosis using M.U.T.-III SE or air bag warning light, if the system is normal and "Stored DTC" of "Self-diagnosis" is indicated, always perform "Erase DTCs" of "Self-diagnosis" using M.U.T.-III SE. Refer to Work Flow Work Flow.
  • After the work is completed, check that no system malfunction is detected by air bag warning light in the user mode.