[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
Seat Belt Pre-tensioner Retractor (LH and RH)
1. Remove rear seat cushion. Refer to Removal and Installation.
2. Remove anchor plate mounting anchor bolt .
3. Remove luggage side lower finisher. Refer to Removal and Installation.
4. Remove shoulder anchor.
(1) Remove shoulder anchor cover.
(2) Remove shoulder anchor mounting anchor bolt , and then remove shoulder anchor.
5. Remove seatback striker. Refer to Removal and Installation.
6. Remove seat belt pre-tensioner retractor mounting anchor bolt .
7. Disconnect seat belt pre-tensioner retractor harness connector .
caution
  • For installing/removing seat belt pre-tensioner retractor harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
  • Install connector with lock raised, and push lock into connector.
  • After installing the connector, check that the lock is pushed securely into it.
8. Remove seat belt pre-tensioner retractor as a set.
cautionNever place pre-tensioner retractor in an area where the temperature reaches 80°C (176°F) or more.
9. Remove luggage side upper finisher. Refer to Removal and Installation.
10. Remove shoulder bracket mounting anchor bolts , and then remove seat belt shoulder bracket.
 
 
Center Seat Belt Retractor
1. Remove rear seat cushion. Refer to Removal and Installation.
2. Disengage harness clip, and then remove anchor bolt .
: Harness clip
3. Remove rear seatback trim and pad as a set. Refer to Disassembly and Assembly.
4. Remove center seat belt retractor mounting anchor nut , and then remove center seat belt retractor as a set.
 
 
INSTALLATION
Install in the reverse order of removal.