[Previous][Next]
Inspection Procedure 2: The speedometer does not work (the other meters work).
 
 
 
 
TECHNICAL DESCRIPTION (COMMENT)
If only the speedometer does not operate, the ASC-ECU and combination meter may have a problem.
 
 
TROUBLESHOOTING HINTS
  • The ASC-ECU may be defective
  • The combination meter may be defective
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Using scan tool MB991958, read the combination meter diagnostic trouble code.
Check if DTC is set to the combination meter.
Is the DTC set?
Troubleshoot the combination meter (Refer to ).
Go to Step 3.
 
STEP 3. Using scan tool MB991958, read the ASC-ECU diagnostic trouble code.
Check if diagnostic trouble code is set to the ASC-ECU.
Is the DTC set?
Troubleshoot the ASC (Refer to GROUP 35C, Diagnosis ).
Go to Step 4.
 
STEP 4. Using scan tool MB991958, check data list.
(1) Turn the ignition switch to the "ON" position.
(2) Check the data list on the combination meter.
  • Item 80: Speedometer
    • Should read vehicle speed.
(3) Turn the ignition switch to the "LOCK" (OFF) position.
Does it read vehicle speed?
Go to Step 5.
Replace the combination meter.
 
STEP 5. Using scan tool MB991958, check actuator test.
(1) Turn the ignition switch to the "ON" position.
(2) Conduct the actuator test of the combination meter.
  • Item 1: Speedometer
    • The speedometer operates up to the set position.
(3) Turn the ignition switch to the "LOCK" (OFF) position.
Is the check result normally?
Go to Step 6.
Replace the combination meter.
 
STEP 6. Retest the system.
Check that the speedometer works normally.
Is the check result normal?
The procedure is complete.
Go to Step 1.