[Previous][Next]
DTC B1133 IG1 setting circuit fail
 
 
cautionWhen replacing the ECU, always check that the communication circuit is normal.
 
 
DIAGNOSTIC FUNCTION
When a short circuit (short to power supply, short to ground) of IG1 setting circuit system is detected, OSS-ECU sets the DTC B1133. At the same time, OSS-ECU displays the power supply system error warning screen to the multi information display of the combination meter, and flashes the indicator of engine switch in orange.
 
 
DTC SET CONDITION
Check Conditions
  • After OSS-ECU activation
Judgment Criterion
  • When the following conditions are met:
    1. When the IG1 signal is ON, the IG1 circuit voltage is less than 1.5 V.
    2. When the IG1 signal is OFF, the IG1 circuit voltage is 3.5 V or more.
 
 
TROUBLESHOOTING HINTS
  • Damaged wiring harness or connector (short to ground or short to power supply in IG1 line)
  • Malfunction of OSS-ECU
  • ETACS-ECU malfunction
 
 
DIAGNOSIS
STEP 1. Check of short circuit in IG1 line between OSS-ECU connector and ETACS-ECU connector
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
 
STEP 2. Voltage measurement at ETACS-ECU connector (IG1 terminal)
(1) Measure the ETACS-ECU connector side by backprobing.
(2) Using the scan tool MB991958, set the forced power supply output to other than "IG-ON" (Refer to forced power supply output procedure ).
(3) Measure the voltage between the ETACS-ECU connector (IG1 terminal) and body ground.
OK: 1 V or less
(4) Using the scan tool MB991958, set the forced power supply output to "IG-ON" (Refer to forced power supply output procedure ).
(5) Measure the voltage between the ETACS-ECU connector (IG1 terminal) and body ground.
OK: Battery voltage
Is the check result normal?
Go to Step 3.
Replace the OSS-ECU and register the VIN (Refer to ).
 
STEP 3. Using scan tool MB991958, check data list.
Check the OSS-ECU data list.
 
Power supply modeItem No.Check itemDisplay
ON15IG1 output (monitor)ON
Other than ONOFF
OK: Depending on the state of power supply mode, the display is turned ON/OFF.
Is the check result normal?
Go to Step 4.
Replace the OSS-ECU and register the VIN (Refer to ).
 
STEP 4. Check whether the DTC is reset.
Is the DTC set?
Replace the ETACS-ECU.
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction )