[Previous][Next]
DTC U0155: Combination meter CAN timeout
 
 
caution
  • If the diagnostic trouble code No. U0155 is set, be sure to diagnose the CAN bus line.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
TROUBLE JUDGMENT
If no signal from the combination meter can be received, KOS-ECU sets the DTC U0155.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of CAN bus line
  • Combination meter malfunction
  • Malfunction of KOS-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool (MB991958), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (MB991958).
Connect scan tool MB991958. Refer to "How to connect the scan tool (M.U.T.-III) ."
(2) Turn the power supply mode of the engine switch to ON.
(3) Diagnose the CAN bus line.
(4) Turn the power supply mode of the engine switch to OFF.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Using scan tool MB991958, read the combination meter diagnostic trouble code
Check if DTC is set to the combination meter.
(1)
cautionTo prevent damage to scan tool (MB991958), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (MB991958).
Connect scan tool MB991958. Refer to "How to connect the scan tool (M.U.T.-III) ."
(2) Turn the power supply mode of the engine switch to ON.
(3) Diagnose the DTC.
(4) Turn the power supply mode of the engine switch to OFF.
Is the DTC set?
Troubleshoot the combination meter. (Refer to GROUP 54A, Diagnosis .)
Go to Step 3.
 
STEP 3. Using scan tool MB991958, read the A/C-ECU <vehicles with A/C> or heater control unit <vehicles without A/C> diagnostic trouble code.
Check if the DTC U0155 is set to the A/C-ECU <vehicles with A/C> or heater control unit <vehicles without A/C>.
Is the DTC set?
Go to Step 4.
Go to Step 5.
 
STEP 4. Recheck for diagnostic trouble code.
Check again if the DTC is set to the KOS-ECU.
(1) Erase the DTC.
(2) Turn the power supply mode of the engine switch from OFF to ON.
(3) Check if DTC is set.
(4) Turn the power supply mode of the engine switch to OFF.
Is the DTC set?
Replace the combination meter.
The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the combination meter and the ETACS-ECU (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).
 
STEP 5. Recheck for diagnostic trouble code.
Check again if the DTC is set to the KOS-ECU.
(1) Erase the DTC.
(2) Turn the power supply mode of the engine switch from OFF to ON.
(3) Check if DTC is set.
(4) Turn the power supply mode of the engine switch to OFF.
Is the DTC set?
Replace KOS-ECU and register the ID codes (Refer to ).
The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the combination meter and the ETACS-ECU (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).