DTC P1D56: Battery Charger ROM Error
DTC P1D57: Battery Charger RAM Error
MONITOR EXECUTION
Once per driving cycle
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC set in memory for the item monitored below)
Not applicable
Sensor (The sensor below is determined to be normal)
Not applicable
DTC SET CONDITIONS
Logic Flow Chart
Check Conditions
OBC power supply voltage is 10 volts to 16 volts.
Judgment Criterion
Status fail.
OBD-II DRIVE CYCLE PATTERN
Refer to OBD-II Drive Cycle - Pattern 1
.
FAIL-SAFE AND BACKUP FUNCTION
The charge is stopped.
PROBABLE CAUSE
The on board charger/DC-DC converter is failed.
DIAGNOSIS
STEP 1. Test the OBD-II drive cycle.
(1)
Carry out a test drive with the drive cycle pattern. Refer to OBD-II Drive Cycle - Pattern 1
.
(2)
Check the DTC.
Is the DTC set?
Replace the on board charger/DC-DC converter (Refer to
). Then go to Step 2
.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions
).
STEP 2. Test the OBD-II drive cycle.
(1)
Carry out a test drive with the drive cycle pattern. Refer to OBD-II Drive Cycle - Pattern 1
.
(2)
Check the DTC.
Is the DTC set?
Retry the troubleshooting.
The inspection is complete.