[Previous][Next]
DTC P1169: Inverter gate driver fails
 
 
danger
  • When servicing the high voltage system parts, always shut off the high voltage by removing the service plug (Refer to ).
  • When servicing the high voltage system parts, always wear the protective equipment or armor to measure the high voltage (Refer to ).
 
 
DESCRIPTIONS OF MONITOR METHODS
  • Overcurrent of the IGBT drive circuit or power supply voltage reduction of the IGBT drive circuit.
 
 
MONITOR EXECUTION
  • Continuous
 
 
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
  • Not applicable
Sensor (The sensor below is determined to be normal)
  • Not applicable
 
 
DTC SET CONDITIONS
Logic Flow Chart
Check Conditions
  • The IGBT status of REMCU is on (Active).
Judgment Criterion
  • IGBT driver power supply voltage less than 12 volts occurs 3 times within 60 seconds.
  • A voltage excess of 0.7 volts between the collector and the emitter occurs 3 times within 60 seconds.
 
 
DTC SET CONDITIONS
Logic Flow Chart
Check Conditions
  • REMCU power supply voltage is 8 volts to 16 volts.
  • The IGBT status of REMCU is off (Shutdown).
Judgment Criterion
  • IGBT driver power supply voltage is less than 12 volts for 0.5 seconds.
  • The voltage between the collector and the emitter is exceeded by 0.7 volts for 0.5 seconds.
 
 
OBD-II DRIVE CYCLE PATTERN
  • Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 4 .
 
 
PROBABLE CAUSES
  • Malfunction of the REMCU
  • Malfunction of the rear motor high-voltage terminal
  • Malfunction of the rear motor assembly
 
 
DIAGNOSIS
STEP 1. Check the high-voltage terminal.
danger
  • Carry out the check on the high-voltage circuit while reading carefully the precautions on handling a high-voltage vehicle.
  • Wear the specified protection equipment during the check.
(1) Shut down the high voltage (Refer to ).
(2) Check that the following cable is tightened to the specified torque.
  • Rear motor cable connection (Refer to ).
Is the check result normal?
Replace the REMCU (Refer to ). Then go to Step 2.
Tighten the rear motor cable to the specified torque (Refer to ). Then go to Step 3.
 
STEP 2. Test the OBD-II drive cycle.
(1) Carry out a test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 4 .
(2) Check the DTC.
Is the DTC set?
Replace the rear motor assembly (Refer to ). Then go to Step 3.
The procedure is complete.
 
STEP 3. Test the OBD-II drive cycle.
(1) Carry out a test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 4 .
(2) Check the DTC.
Is the DTC set?
Retry the troubleshooting.
The inspection is complete.