<REMCU>
1. Remove cargo floor box lid A, cargo floor box lid D, and cargo floor box. (Refer to GROUP 52A - Interior Trim .) 2. Remove the EV motor control unit cover. (Refer to .) 3. Remove the service lid. (Refer to .) 4. Remove the mounting screws and remove the high-voltage fuse Nos 4 and 5.
5. Check the resistance between the high-voltage fuses, and if there is no continuity (open circuit), replace the high-voltage fuses.
6. caution | When tightening the installation screws, secure the high-voltage fuse terminal portion, because there is a risk of damage to the high-voltage fuse when an excessive force applies to the high-voltage fuse main body. |
Tighten each installation screw to the specified torque.
Tightening torque: 7.0 ± 3.0 N·m (62 ± 26 in-lb)
7. Install the service lid. (Refer to .) 8. Install the EV motor control unit cover. (Refer to .) 9. Install cargo floor box lid A, cargo floor box lid D, and cargo floor box. (Refer to GROUP 52A - Interior Trim .)