[Previous][Next]
REMOVAL AND INSTALLATION
caution
  • To replace the electrical parking actuator, disconnect the negative terminal of the 12V Starter Battery and initialize the electrical parking driver unit.
  • If the 12V Starter Battery is disconnected, the control timer which operates the engine forcibly will be reset. If the engine does not start for prolonged period after the reset, the fuel injection system may be clogged. To avoid this, press the battery charging switch to start the engine. Note that the battery charging switch may not be turned on if the Main Drive Lithium-ion Battery is almost fully charged. In that case, wait until the Main Drive Lithium-ion Battery is partially discharged.
 
 
Pre-removal and post-installation operation
  • Air cleaner cover removal and installation (Refer to GROUP 15 - Air Cleaner ).
  • Engine coolant draining and refilling (Refer to GROUP 14A - On-vehicle Service ).
  • Throttle body water feed hose disconnection and connection (Refer to GROUP 13A - Throttle Body Assembly ).
  • Radiator upper hose and lower hose disconnection and connection (Refer to GROUP 14A - Radiator ).
Removal steps
>>A<<1.Electrical parking actuator
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< ELECTRICAL PARKING ACTUATOR INSTALLATION
1.
caution
  • Do not touch the air breather.
  • Be careful not to damage the actuator and the O-ring.
Apply ATF to the O-ring.
2. Engage the spline to install the electrical parking actuator to the front transaxle assembly.