[Previous][Next]
Inspection Procedure 3: Vehicle power does not turn ON. (Not possible with power supply mode ACC only)
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
 
 
TECHNICAL DESCRIPTION (COMMENT)
When the vehicle power does not turn ON (not possible with power supply mode ACC only), the possible cause may be that the OSS-ECU cannot output the ACC signal, or that the ACC internal relay of ETACS-ECU does not turn ON. Therefore, OSS-ECU or ETACS-ECU may have a problem.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of OSS-ECU
  • Malfunction of ETACS-ECU
  • Damaged harness wires and connectors
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-III), read the diagnostic trouble code.
Check if the diagnosis trouble code is set in the OSS-ECU.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect scan tool (M.U.T.-III) ."
(2) Turn the power supply mode of the engine switch to ON.
(3) Check if DTC is set.
(4) Turn the power supply mode of the engine switch to OFF.
Is the DTC set?
Refer to diagnostic trouble code chart .
Go to Step 2.
 
STEP 2. Voltage measurement at ETACS-ECU connector (ACC terminal)
(1) With the ETACS-ECU connector kept connected, measure by backprobing.
(2) Using the scan tool (M.U.T.-III), set the forced power supply output to "IG-ACC" (Refer to ).
(3) Measure the voltage between the ETACS-ECU connector (ACC terminal) and body ground.
OK: The voltage should measure approximately 12 volts (battery positive voltage).
Is the check result normal?
Go to Step 3.
Replace the OSS-ECU and register the VIN (Refer to ).
 
STEP 3. Check of the troubles
Check that the vehicle power (power supply mode ACC) can be turned ON.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Carry out the troubleshooting relevant to the input signal of ETACS-ECU. (Refer to GROUP 54A - ETACS .)