[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Door Trim Assembly Removal (Refer to GROUP 52A, Door Trim ).
  • Door Waterproof Film, Door Speaker Bracket, Door Working Hole Cover Front, Door Working Hole Cover Rear Removal (Refer to ).
Post-installation Operation
  • Door Inside Handle Play Check (Refer to ).
  • Door Outside Handle Play Check (Refer to ).
  • Door Waterproof Film, Door Speaker Bracket, Door Working Hole Cover Front, Door Working Hole Cover Rear Installation (Refer to ).
  • Door Trim Assembly Installation (Refer to GROUP 52A, Door Trim ).
Door inside handle removal
1.Door inside handle
Door latch assembly removal steps
2.Door outside handle cover
3.Door lock key cylinder (driver's side) <Vehicles with door lock key cylinder>
4.Door outside handle rod
5.Clip
6.Bolt
7.Door latch and cable assembly
<<A>>8.Door lock cover
>>B<<9.Door inside lock cable
>>B<<10.Door inside handle cable
<<A>>11.Door latch assembly
Door outside handle removal steps
2.Door outside handle cover
3.Door lock key cylinder (driver's side) <Vehicles with door lock key cylinder>
12.Door outside handle
13.Door outside handle gasket
4.Door outside handle rod
5.Clip
14.Door outside handle base
Door check removal
>>A<<15.Door check
Door inside handle removal
1.Door inside handle
Door latch assembly removal steps
2.Door outside handle rod
3.Clip
4.Bolt
5.Door latch and cable assembly
<<A>>6.Door lock cover
>>B<<7.Door inside lock cable
>>B<<8.Door inside handle cable
<<A>>9.Door latch assembly
Door outside handle removal steps
10.Door outside handle cover
11.Door outside handle
12.Door outside handle gasket
2.Door outside handle rod
3.Clip
13.Door outside handle base
Door check removal
>>A<<14.Door check
 
 
REMOVAL SERVICE POINT
 
 
<<A>> DOOR LOCK COVER/ DOOR LATCH ASSEMBLY REMOVAL
Remove the door lock cover in the following procedures:
1. Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver.
2. Pull the cover out a little.
3. With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< DOOR CHECK INSTALLATION
Install the door check with the following identification mark facing upward.
 
ApplicationIdentification mark
Front doorLeft doorFL
Right doorFR
Rear doorLeft doorRL
Right doorRR
 
 
 
>>B<< DOOR INSIDE LOCK CABLE/ DOOR INSIDE HANDLE CABLE INSTALLATION
Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification color marked on the cables as shown in the illustration.