STEP 3. Measure the voltage at the electric parking brake ECU connector.
(1) Disconnect the electric parking brake ECU connector and measure at the wiring harness side.
(2) Measure the voltage between the +B2 terminal and body ground.OK: Battery voltage
Is the check result normal?
Go to Step 4. The power supply circuit may be open or short to ground. Repair the wiring harness wires or connectors between the electric parking brake ECU connector and the battery.
STEP 4. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Check again if the DTC is set.(1) caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect scan tool (M.U.T.-IIISE). Refer to "How to Connect the Scan Tool (M.U.T.-IIISE)
."
(2) Erase the DTC.
(3) Turn the ignition switch to the LOCK (OFF) position.
(4) Turn the ignition switch to the ON position.
(5) Check the DTC.
Is the DTC C2304 set?
Replace the electric parking brake ECU (Refer to ). The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).