STEP 1. Using scan tool (M.U.T.-IIISE), check DTC.
STEP 2. Check whether the ASC-ECU is installed properly.
STEP 3. Using scan tool (M.U.T.-IIISE), check data list.
STEP 4. Check whether the DTC is set again.
(1) Turn the ignition switch to the "LOCK" (OFF) position.
(2) Turn the ignition switch to the "ON" position.
(3) Drive the vehicle at 20 km/h (12 mph) or higher.note | The ABS warning light does not turn OFF in some cases unless the vehicle runs at 20 km/h (12 mph) or higher. |
Is DTC C1242 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ). Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How to Cope with Intermittent Malfunctions ).