[Previous][Next]
DTC U1195: Coding not completed
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When DTC U1195 is set in ACC/FCM-ECU, the DTC may also be set in ETACS-ECU. When the DTC is set in ETACS-ECU, perform the diagnosis of the DTC for ETACS-ECU first.
  • When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in GROUP 54A, Immobilizer System - How to Register Key ID .)
  • When the ACC/FCM-ECU is replaced, calibrate the radar (refer to ).
 
 
OPERATION
ACC/FCM-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DIAGNOSTIC TROUBLE CODE SET CONDITION
Check Condition
  • Ignition switch is "ON" position.
Judgment Criterion
  • Coding has not been performed.
noteA DTC is not set as a historic fault.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Coding not implemented
  • ETACS-ECU malfunction
  • Malfunction of ACC/FCM-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), diagnose CAN bus line.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line [Refer to GROUP 54C - Explanation About The Scan Tool (M.U.T.-IIISE) CAN Bus Diagnostics ].
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Diagnosis, CAN Bus Diagnostics Table ).
 
STEP 2. Using scan tool (M.U.T.-IIISE), check the ETACS DTC.
Using scan tool (M.U.T.-IIISE), perform ETACS DTC (Refer to GROUP 54A - ETACS, Diagnosis, Diagnostic Function ).
Is DTC B222C set?
Perform ETACS coding operation.
Go to Step 3.
 
STEP 3. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Is DTC U1195 set?
Replace the ACC/FCM-ECU (Refer to ).
This diagnosis is complete.