[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
cautionDuring diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
DTC No.ItemReference page
C1394INCOMP.learn neutral(SAS)
C1705LDW SW circuit low (short)
C1707Implausible coding data
C1747Shift signal undetermined
C1750Voltage out of range
C1751ECU failure
C1752Radar temperature out of range
C1753Radar blockage detected
C1754Radar calibration not completed
C1777System fail detected (ASC)
C1778Vehicle speed signal fail
C1779Brake master cylinder PRS.signal
C1781SAS fail
C1782SAS signal fail
C1784FCM switch fixed ON
C1787APS signal
C1788Longitudinal G sensor signal
C1791Vehicle speed signal (invalid)
C1792Brake M/C PRS. signal (invalid)
C1793Lateral ACC. signal (invalid)
C1794Longitudinal G signal (invalid)
C1795Yaw rate signal (invalid)
C1796APS signal (invalid)
C1798FCM control disabled (ASC)
C2256Brake switch signal fail
C2271SAS signal fail
C2272Delta SAS signal fail
C2276Brake switch signal
C2292Auto calibration out of range
C2298Ambient sensor signal
C2299Implausible coding data
C2351FCM state from ACC/FCM ECU signal (invalid)
C2352Received FCM system fail from ACC/FCM ECU
C2353Received FCM temporary fail from ACC/FCM ECU
C2354FCM mode disagreement detection
U0100Engine CAN timeout
U0101T/M CAN timeout
U0121ABS/ASC CAN timeout
U0126SAS CAN timeout
U0141ETACS CAN timeout
U1190No receive fault detect signal
U1195Coding not completed
U15A0ACC/FCM ECU CAN timeout