Using scan tool (M.U.T.-IIISE), read the DTC again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.(1) caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE)
."
(2) Erase the DTC.
(3) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(4) Check if the DTC is set.
Is the DTC set?
Replace the FCM/LDW/AHB-ECU (Refer to ). The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).