STEP 1. Check the wiring harness between side-view camera (LH) connector and camera-ECU connector.
STEP 2. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Check again if the DTC is set in the camera-ECU.(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check the DTC.
Is the DTC set?
Go to Step 3. The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
STEP 3. Check the side-view camera (LH).
STEP 4. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Check again if the DTC is set in the camera-ECU.(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check the DTC.
Is the DTC set?
Replace the camera-ECU (Refer to ). The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).