[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Post-installation operation
  • Door window glass adjustment (Refer to .)
  • Learning procedures of the power window fully closed position <Vehicles with safety system> (Refer to .)
Door window glass assembly removal
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film (Refer to )
<<B>>1.Door window glass assembly
Power window regulator removal steps
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film, Front lower sash assembly, Door window glass runchannel (Refer to )
<<B>>>>A<<2.Power window regulator assembly
3.Power window regulator motor
noteFor removal and installation of the power window switch, refer to GROUP 52A, Door Trim .
Required Special Tool:
  • MB990480: Window glass holder
Door window glass assembly removal steps
<<A>>>>B<<1.Clip <Manual window regulator>
>>B<<2.Regulator handle <Manual window regulator>
>>B<<3.Escutcheon <Manual window regulator>
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film, Rear door window center sash, Door window glass runchannel (Refer to )
<<B>>4.Door window glass assembly
Power window regulator removal steps
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film (Refer to )
<<B>>>>A<<5.Power window regulator assembly
6.Power window regulator motor
Manual window regulator removal steps
<<A>>>>B<<1.Clip
>>B<<2.Regulator handle
>>B<<3.Escutcheon
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film (Refer to )
<<B>>>>A<<7.Manual window regulator assembly
Stationary window glass removal steps
•Door trim assembly (Refer to GROUP 52A, Door trim )
•Waterproof film, Rear door window center sash (Refer to )
8.Stationary window weatherstrip
9.Stationary window glass
10.Seal pad
noteFor removal and installation of the power window switch, refer to GROUP 52A, Door Trim .
Required Special Tool:
  • MB990480: Window glass holder
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> CLIP REMOVAL
Use cloth to remove the clip as shown in the illustration.
 

 
 
<<B>> DOOR WINDOW GLASS ASSEMBLY/POWER WINDOW REGULATOR ASSEMBLY/MANUAL WINDOW REGULATOR ASSEMBLY REMOVAL
1. Remove the door window glass mounting bolts.
cautionIf any film or the like is applied to a door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
2. Lift the door window glass, and attach the special tool MB990480 to the glass as shown to prevent the glass from falling.
3. Remove the power window regulator assembly.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< MANUAL WINDOW REGULATOR ASSEMBLY/POWER WINDOW REGULATOR ASSEMBLY INSTALLATION
Tighten the power window regulator assembly/manual window regulator assembly installation bolts to the specified torque in the order shown in the illustration.
Tightening torque: 9.5 ± 2.5 N·m (84 ± 22 in-lb)
 
 
 
>>B<< ESCUTCHEON/REGULATOR HANDLE/CLIP INSTALLATION
1. Install escutcheon and regulator handle to the clip.
2. Close the door window glass fully, and then install the regulator handle as shown in the illustration.