[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Waterproof film removal steps 
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
>>A<<1.Waterproof film
Door window glass runchannel removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
2.Door window glass runchannel
Door beltline weatherstrip inner removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
3.Door beltline weatherstrip inner
Door beltline molding removal steps
•Door mirror assembly (Refer to GROUP 51, Door Mirror .)
4.Door beltline molding
Front lower sash removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
>>A<<1.Waterproof film
5.Front lower sash assembly
6.Front lower sash
7.Door window glass runchannel rear
Door opening weatherstrip inner removal steps
•Cowl side trim and front scuff plate (Refer to GROUP 52A, Interior Trim .)
8.Door opening weatherstrip inner
Door opening weatherstrip outer removal steps
9.Door check connecting bolt
<<A>>10.Door opening weatherstrip outer
 
 
Waterproof film removal steps 
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
>>A<<1.Waterproof film
Rear door window center sash removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
>>A<<1.Waterproof film
<<A>>2.Rear door window center sash
Door window glass runchannel removal
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
3.Door window glass runchannel
Door beltline weatherstrip inner removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim .)
4.Door beltline weatherstrip inner
Door beltline molding removal
5.Door beltline molding
Door opening weatherstrip inner removal
6.Door opening weatherstrip inner
Door opening weatherstrip outer removal steps
7.Door check connecting bolt
<<B>>8.Door opening weatherstrip outer
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> REAR DOOR WINDOW CENTER SASH REMOVAL
1. Remove the door outer opening weatherstrip from the door center sash only.
2. Remove the door center sash mounting screws, and then remove the door center sash from the door panel.
 

 
 
<<B>>DOOR OPENING WEATHERSTRIP OUTER REMOVAL
Make the tool as shown in the figure, and remove the weatherstrip from the door panel.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< WATERPROOF FILM INSTALLATION
cautionWhen a waterproof film is applied, guide the butyl rubber tape under the inner panel drain hole.
Apply the specified adhesive to the waterproof film as shown in the figure and stick the film.
Specified sealant: 3M™ AAD Part No. 8625 or equivalent