[Previous][Next]
Code No. U1100 Engine CAN timeout
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
  • If diagnostic trouble code U1100 is set in ASC-ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect diagnostic trouble code may be set. In this case, the set diagnostic trouble code is not highly reliable.
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
  • When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor and the G and yaw rate sensor (Refer to and ).
 
 
OPERATION
The ASC-ECU communicates with the engine control module via the CAN bus lines.
 
 
DIAGNOSTIC TROUBLE CODE SET CONDITIONS
The ASC-ECU receives the engine control system-related signals from the engine control module via the CAN bus lines. When these signals cannot be received, the ECU sets this diagnostic trouble code.
 
 
PROBABLE CAUSES
  • The CAN bus line is defective.
  • Malfunction of engine control module
  • Malfunction of ASC-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use the scan tool MB991958 to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 3.
Repair the CAN bus line (Refer to GROUP 54C, Troubleshooting ). On completion, go to Step 2.
 
STEP 2. Diagnostic trouble code recheck after resetting CAN bus lines
Is diagnostic trouble code No. U1100 set?
Go to Step 3.
This diagnosis is complete.
 
STEP 3. Use scan tool MB991958 to confirm a diagnostic trouble code of other systems.
Check if the diagnostic trouble code is set in the engine control module (Refer to GROUP 13A, Diagnostic Trouble Code Chart ).
Is the diagnostic trouble code set?
Troubleshoot the engine control module diagnostic trouble code. Then go to Step 5.
Go to Step 4.
 
STEP 4. Use scan tool MB991958 to confirm a diagnostic trouble code of other systems.
Check whether an engine "time-out" related diagnostic trouble code is set in other ECUs.
Is the diagnostic trouble code set?
Replace the engine control module (Refer to GROUP 13A, engine control module ). Then go to Step 5.
Go to Step 5.
 
STEP 5. Check whether the diagnostic trouble code is set again.
Check again if the diagnostic trouble code is set.
(1) Erase the set diagnostic trouble code.
(2) Ignition switch: "LOCK" (OFF)
(3) Ignition switch: "ON"
Is diagnostic trouble code No. U1100 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).