DTC P0976: Malfunction of the High Clutch and Reverse Brake Solenoid Valve (short to ground)
DIAGNOSTIC FUNCTION
If a predetermined current does not flow into the high clutch and reverse brake solenoid valve (short to ground), the TCM will determine the system is defective.
DESCRIPTIONS OF MONITOR METHODS
Owing to short to ground, more current than predetermined flows into the high clutch and reverse brake solenoid valve drive circuit.
MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
Sensor (The sensor below is determined to be normal)
LOGIC FLOW CHARTS (Monitor Sequence)
DTC SET CONDITIONS
Check Conditions
- Voltage of battery: 10 volts or more.
- Voltage of battery: 16.5 volts or less.
Judgment Criteria
- A current of at least 1.78 A flows into the high clutch and reverse brake solenoid valve drive circuit for 0.2 seconds.
OBD-II DRIVE CYCLE PATTERN
Ignition switch: "ON" position (start the engine and keep it for 5 seconds or more)
PROBABLE CAUSES
- Malfunction of the valve body assembly (Defective high clutch and reverse brake solenoid valve)
- Damaged wiring harness and connectors
- Malfunction of TCM