[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove front grille cover. Refer to Removal and Installation .
2. Remove  air duct inlet. Refer to Removal and Installation.AIR CLEANER REMOVAL AND INSTALLATION .
3. Release the lock as shown by the arrow in the figure and disconnect the harness connector from the distance sensor.
4. Remove bolts and remove distance sensor bracket (if necessary).
5. Remove distance sensor nuts and remove distance sensor .
 
 
INSTALLATION
Note the following items, and then installation is in the reverse order of removal.
caution
  • If distance sensor is being replaced or has been disconnected, perform "ADDITIONAL SERVICE WHEN REPLACING DISTANCE SENSOR". Refer to Work Procedure.
  • Do not touch distance sensor face.
  • Do not drop or shock distance sensor.
  • Make sure distance sensor harness is installed without any twists.