When the electric motor switch is changed to ON after the TCU is replaced with the new one, the data will be updated by connecting to the server. Change the electric motor switch to ON, and wait approximately five minutes. The updating data will be completed and the TCU can communicate with the server. Talk with a call center from your information switch to check that the updating data is correctly completed, before delivering the vehicle to the user.
When the TCU is replaced with the new one, perform the "ADDITIONAL SERVICE WHEN REPLACING TCU". Refer to Work Procedure.
Pre-removal and Post-installation Operation
Glove box assembly Removal (Refer to Glove Box and Center Ventilator Finisher Removal and Installation)
Passenger knee air bag module Removal and Installation (Refer to Passenger Knee Air Bag Module Removal and Installation)
Removal steps
1.
TCU
•
Instrument Panel Assembly Removal and Installation (Refer to Instrument Panel Assembly Removal and Installation Removal and Installation)
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
