[Previous][Next]
DTC Description
 
 
DESCRIPTION
CAN (Controller Area Network) is a serial communication line for real-time application. It is an onvehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independently). In CAN communication, control units are connected with 2 communication lines (CAN-H, CAN-L) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
U0079-00Control module comm Bus G Off
(Control module communication bus "G" off)
Diagnosis conditionWhen electric motor switch is ON
Signal (terminal)CAN communication signal
ThresholdTransmission or reception error
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
CAN communication system
 
 
FAIL-SAFE
Telematics system does not operate
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the electric motor switch ON.
  2. Turn the electric motor switch OFF and wait at least 30 seconds.
  3. Turn the electric motor switch ON and wait at least 30 seconds or more.
  4. Select “Diagnostic Trouble Code” mode of “IVC” using M.U.T.-III SE.
  5. Check DTC.
Is DTC U0079-00 detected?
Refer to Diagnosis ProcedureDiagnosisProcedure.
-1To check malfunction symptom before repair: Refer to Intermittent Incident.
-2Confirmation after repair: INSPECTION END