[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal operation
Post-installation operation
Front door glass removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
3.Front door glass
Front door regulator assembly removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
3.Front door glass
Front door power window motor connector connection
4.Front door regulator assembly
Front door power window motor removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
3.Front door glass
Front door power window motor connector connection
4.Front door regulator assembly
5.Front door power window motor
noteFor removal and installation of the power window switch (Refer to Door trim Removal and Installation).
Rear door glass removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
Door window glass lower runchannel (Refer to REMOVAL AND INSTALLATION)
Rear side guard molding (Refer to side guard molding Removal and Installation)
3.Rear door glass
Rear door regulator assembly removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
Door window glass lower runchannel (Refer to REMOVAL AND INSTALLATION)
Rear side guard molding (Refer to side guard molding Removal and Installation)
3.Rear door glass
4.Rear door regulator assembly
Rear door power window motor removal steps
1.Door working hole front cover
2.Door working hole rear cover
Door beltline inner weatherstrip (Refer to REMOVAL AND INSTALLATION)
Door window glass lower runchannel (Refer to REMOVAL AND INSTALLATION)
Rear side guard molding (Refer to side guard molding Removal and Installation)
3.Rear door glass
4.Rear door regulator assembly
5.Rear door power window motor
noteFor removal and installation of the power window switch (Refer to Door trim Removal and Installation).
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT DOOR GLASS/REAR DOOR GLASS/FRONT DOOR REGULATOR ASSEMBLY/REAR DOOR GLASS REGULATOR ASSEMBLY REMOVAL
1. Align the glass holder mounting bolt on the door window glass with the service hole to remove it.
cautionIf any film or the like is applied to a door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
2. Lift the door window glass, and attach the special tool MB990480 to the glass as shown to prevent the glass from falling.
3. Slant the door window glass and remove it upward from the inside of the door <Rear door>.
4. Remove the door regulator assembly.