REMOVAL AND INSTALLATION
Pre-removal operation
Side Guard Molding Removal (Refer to
Removal and Installation
)
Post-installation operation
Side Guard Molding Installation (Refer to Side Guard Molding
Removal and Installation
)
Door Adjustment (Refer to
DOOR FIT ADJUSTMENT
)
Front door assembly removal steps
1.
Wiring harness connector connection
2.
Door check connecting bolt
3.
Front door assembly
Front door hinge removal steps
3.
Front door assembly
4
Front door hinge (upper)
5.
Front door hinge (lower)
Striker removal steps
6.
Front door striker
7.
Shim
Bumper removal
8.
Bumper
Rear door assembly removal steps
1.
Wiring harness connector connection
2.
Door check connecting bolt
3.
Rear door assembly
Rear door hinge removal steps
3.
Rear door assembly
•
Center pillar lower garnish (Refer to Interior Trim
Removal and Installation
)
4.
Rear door hinge (upper)
5.
Rear door hinge (lower)
Striker removal steps
6.
Rear door striker
7.
Shim
INSTALLATION SERVICE POINT
>>A<< STRIKER INSTALLATION
Align the centre of the striker and latch within ± 1.5 mm (0.06 inch), and install.