Removal and Installation
Pre-removal and Post-installation Operation
Back door lock release handle Removal and Installation (Refer to Back Door
REMOVAL AND INSTALLATION
<Vehicles without Power Liftgate>,
REMOVAL AND INSTALLATION
<Vehicles with Power Liftgate>)
License Plate Light Assembly Removal and Installation (Refer to License Plate Light
Removal and Installation
)
Removal steps
1.
Back door finisher
2.
Three-diamond mark
3.
Back door finisher bracket
Required special tools:
MB990784: Ornament remover
REMOVAL SERVICE POINT
<<A>> BACK DOOR FINISHER REMOVAL
1.
Use a socket wrench to remove clips A shown in the figure by pushing them from the inside of the vehicle.
2.
Disconnect clips B shown in the figure from the back door finisher bracket by using the ornament remover (MB990784).
3.
Remove the other clips, and remove the back door finisher.
INSTALLATION SERVICE POINT
>>A<< BACK DOOR FINISHER INSTALLATION
caution
When installing the back door finisher, roll up the back door lower dam and secure it by a tape as shown to avoid trapping it.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
