[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Lower the front suspension member by approximately 15 mm (0.6 in) to separate the connection of the transverse link and the steering knuckle (lower side). Refer to Removal and Installation.
2. Remove transverse link mounting bolts and nuts , and then remove transverse link from suspension member.
3. Perform inspection after removal. Refer to Inspection Inspection.
 
 
INSTALLATION
Note the following, and install in the reverse order of removal.
  • Never reuse transverse link mounting nut.
  • Perform final tightening of bolts and nuts at the vehicle installation position (rubber bushing), under unladen conditions with tires on level ground.
  • Perform inspection after installation. Refer to Inspection Inspection.