[Previous][Next]
REMOVAL AND INSTALLATION
danger
Pre-removal Operation
Post-installation Operation
 
 
Removal steps
1.High voltage sensor cover <Vehicle with quick charging system>
2.High voltage sensor (for quick charging) connector connection <Vehicle with quick charging system>
3.Interlock connector bracket
4.High voltage sensor (for quick charging) <Vehicle with quick charging system>
5.Junction box upper lid
6.On Board Charger (OBC)/DC-DC converter & junction box front bracket
7.On Board Charger (OBC)/DC-DC converter & junction box rear bracket
8.Junction box protector
On Board Charger (OBC)/DC-DC converter cable connection (Refer to ON BOARD CHARGER (OBC) &DC-DC CONVERTER REMOVAL AND INSTALLATION)
EV home & quick charger cable connection (Refer to ON BOARD CHARGER (OBC) &DC-DC CONVERTER REMOVAL AND INSTALLATION)
9.Junction box
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< JUNCTION BOX UPPER LID INSTALLATION
cautionWhen reusing the junction box upper lid, check that the junction box upper lid and bracket are not damaged or deformed.
1. If the junction box upper lid or bracket is damaged or deformed, replace it.
2. Apply the label on the replaced junction box upper lid as shown in the illustration.