ENGINE OIL PRESSURE SWITCH REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

Pre-removal and Post-installation Operation

Splash Shield Removal and Installation (Refer to Body Exterior, Doors, Roof & Vehicle Security - Exterior REMOVAL AND INSTALLATION)
A/C Compressor Harness Protector Bracket Removal and Installation (Refer to Ventilation, Heater & Air Conditioner - Heater & Air Conditioning System Removal and Installation)
Oil Dipstick Guide Removal and Installation (Refer to Engine Overhaul INTAKE MANIFOLD REMOVAL AND INSTALLATION)

			Removal
		1.	Engine oil pressure switch

REMOVAL SERVICE POINT

<<A>> ENGINE OIL PRESSURE SWITCH REMOVAL

caution

The sealant is applied to the bolt. Remove the bolt with care not to break it.

Use special tool oil pressure switch wrench (MB992118) to remove the engine oil pressure switch.

INSTALLATION SERVICE POINT

>>A<< ENGINE OIL PRESSURE SWITCH INSTALLATION

1. Apply sealant to the engine oil pressure switch thread.

Specified sealant: ThreeBond 1215 or equivalent

note	Install the engine oil pressure switch immediately after applying sealant.

caution

After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the engine oil or water to the sealant application area or start the engine.

2. In the same manner as removal, use special tool oil pressure switch wrench (MB992118) to tighten the engine oil pressure switch to the specified torque.

Tightening torque: 10 ± 2 N·m (89 ± 17 in-lb)