Removal and Installation
caution
When the distance sensor is replaced, after turning the ignition switch ON or OFF, always carry out the calibration of radar at one time.
If distance sensor is being replaced or has been disconnected, perform "ADDITIONAL SERVICE WHEN REPLACING DISTANCE SENSOR". Refer to
Work Procedure
.
Do not touch distance sensor face.
Do not drop or shock distance sensor.
Make sure distance sensor harness is installed without any twists.
Pre-removal and Post-installation Operation
Front Bumper Assembly Removal and Installation (Refer to
FRONT BUMPER ASSEMBLY REMOVAL AND INSTALLATION
).
Removal steps
1.
Distance sensor
2.
Distance sensor bracket
3.
Hood striker assembly