[Previous][Next]
Diagnosis Procedure (With automatic drive positioner system)
1.CHECK POWER WINDOW MAIN SWITCH CIRCUIT
  1. Ignition switch OFF.
  2. Disconnect power window main switch connector and door mirror LH connector.
  3. Check continuity between power window main switch harness connector and door mirror LH harness connector.
    Power window main switchDoor mirror LHContinuity
    ConnectorTerminalConnectorTerminal
    D62D166Existed
    610
    75
    813
    103
    1414
    212
  4. Check continuity between power window main switch harness connector and ground.
    Power window main switchContinuity
    ConnectorTerminal
    D62GroundNot existed
    6
    7
    8
    10
    14
    21
Is the inspection result normal?
.
Repair or replace harness.
 
2.REPLACE DOOR MIRROR LH
Replace door mirror LH. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
3.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
4.REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
5.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
: INSPECTION END