[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Drain gear oil. Refer to Draining.
2. Remove rear drive shafts. Refer to Removal and Installation.
3. Remove side oil seal, using oil seal remover (commercial service tool).
cautionNever damage gear carrier and rear cover.
 
 
INSTALLATION
 
 
1. Using the drift (A) (commercial service tool), drive side oil seal until it becomes flush with the gear carrier end.
caution
  • Never reuse oil seal.
  • When installing, never incline oil seal.
  • Check that the oil seal lip is filled up with grease.
  • Apply gear oil lightly and evenly onto the outer circumference of oil seal.
2. Install rear drive shafts. Refer to Removal and Installation.
3. Refill gear oil to the final drive. Refer to Refilling.
4. Check the oil level and the oil leakage after installation. Refer to Inspection .