[Previous][Next]
DTC Diagnosis Procedure
1.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND MOTOR COIL A
  1. Ignition switch OFF.
  2. Disconnect the electric shift control module connector.
  3. Disconnect the shift actuator connector.
  4. Check the continuity electric shift control module harness connector terminals and shift actuator harness connector terminals.
    Electric shift control moduleShift actuatorContinuity
    ConnectorTerminalConnectorTerminal
    E1301F976Existed
    27
    58
  5. Check the continuity electric shift control module harness connector terminals and ground.
    Electric shift control moduleContinuity
    ConnectorTerminal
    E1301GroundNot existed
    2
    5
Is the inspection result normal?
.
Repair or replace damaged parts.
 
2.CHECK SHIFT ACTUATOR RELAY A
Check the shift actuator relay A. Refer to Component Inspection (Shift Actuator Relay A).
Is the inspection result normal?
Replace the shift actuator relay A.
 
3.CHECK HARNESS BETWEEN SHIFT ACTUATOR RELAY A AND BATTERY
Check the voltage shift actuator relay harness connector terminal and ground.
+-ConditionVoltage
Shift actuator relay
ConnectorTerminal
E1487GroundAlways9 – 16 V
8Ignition switch is ON9 – 16 V
Ignition switch is OFF0 V
Is the inspection result normal?
.
.
 
4.DETECT MALFUNCTIONING ITEMS
Check the following items:
  • Harness for short or open between shift actuator relay harness connector terminal 7 and battery
  • Harness for short or open between shift actuator relay harness connector terminal 8 and fuse block (J/B) harness connector terminal 23F
  • Battery
  • Ignition switch
  • Fuse block (J/B)
  • 20A fuse (#87)
  • 10A fuse [#44, located in the fuse block (J/B)]
Is the inspection result normal?
INSPECTION END
Repair or replace damaged parts.
 
5.CHECK HARNESS BETWEEN SHIFT ACTUATOR AND SHIFT ACTUATOR RELAY A
Check the continuity shift actuator harness connector terminal and shift actuator relay harness connector terminal.
Shift actuatorShift actuator relayContinuity
ConnectorTerminalConnectorTerminal
F975E1486Existed
Is the inspection result normal?
.
Repair or replace damaged parts.
 
6.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND SHIFT ACTUATOR RELAY A
  1. Check the continuity electric shift control module harness connector terminal and shift actuator relay harness connector terminal.
    Electric shift control moduleShift actuator relayContinuity
    ConnectorTerminalConnectorTerminal
    E13018E1489Existed
  2. Check the continuity electric shift control module harness connector terminal and ground.
    Electric shift control moduleContinuity
    ConnectorTerminal
    E13018GroundNot existed
Is the inspection result normal?
.
Repair or replace damaged parts.
 
7.CHECK MOTOR COIL A
Check the motor coil A (shift actuator). Refer to Component Inspection (Motor Coil A).
Is the inspection result normal?
INSPECTION END
Replace the transaxle assembly due to malfunction in the motor coil A (shift actuator). Refer to Remove and InstallationRemoval and Installation.