[Previous][Next]
DTC Diagnosis Procedure
1.CHECK DTC PRIORITY
If P0122 or P0123 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC Description.
.
 
2.CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY
  1. Turn ignition switch OFF.
  2. Disconnect electric throttle control actuator harness connector.
  3. Turn ignition switch ON.
  4. Check the voltage between electric throttle control actuator harness connector and ground.
    +−Voltage
    (Approx.)
    Electric throttle control actuator
    ConnectorTerminal
    F503Ground5 V
Is the inspection result normal?
.
.
 
3.CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY CIRCUIT
  1. Turn ignition switch OFF.
  2. Disconnect ECM harness connector.
  3. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
    +−Continuity
    Electric throttle control actuatorECM
    ConnectorTerminalConnectorTerminal
    F503F5162Existed
  4. Also check harness for short to power.
Is the inspection result normal?
Perform the trouble diagnosis for power supply circuit.
Repair or replace error-detected parts.
 
4.CHECK THROTTLE POSITION SENSOR 2 GROUND CIRCUIT
  1. Turn ignition switch OFF.
  2. Disconnect ECM harness connector.
  3. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
    +−Continuity
    Electric throttle control actuatorECM
    ConnectorTerminalConnectorTerminal
    F502F5145Existed
Is the inspection result normal?
.
Repair or replace error-detected parts.
 
5.CHECK THROTTLE POSITION SENSOR 2 INPUT SIGNAL CIRCUIT
  1. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
    +−Continuity
    Electric throttle control actuatorECM
    ConnectorTerminalConnectorTerminal
    F504F5152Existed
  2. Also check harness for short to ground and to power.
Is the inspection result normal?
.
Repair or replace error-detected parts.
 
6.CHECK THROTTLE POSITION SENSOR
Check the throttle position sensor. Refer to Component Inspection.
Is the inspection result normal?
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
Replace electric throttle control actuator. Refer to Removal and Installation.