[Previous][Next]
Component Inspection
1.CHECK THROTTLE POSITION SENSOR
  1. Turn ignition switch OFF.
  2. Reconnect all harness connectors disconnected.
  3. Perform “ Throttle Valve Closed Position Learning”. Refer to Work Procedure.
  4. Turn ignition switch ON.
  5. Set selector lever to D position.
  6. Check the voltage between ECM harness connector terminals as per the following conditions.
    ECMConditionVoltage
    Connector+
    Terminal
    Sensor 1F515762Accelerator pedalFully releasedMore than 0.36V
    Fully depressedLess than 4.75V
    Sensor 252Fully releasedLess than 4.75V
    Fully depressedMore than 0.36V
Is the inspection result normal?
INSPECTION END
Replace electric throttle control actuator. Refer to Exploded ViewRemoval and Installation.