1.CHECK AIR FUEL RATIO (A/F) SENSOR 1 POWER SUPPLY
2.CHECK A/F SENSOR 1 POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect IPDM E/R harness connector.
- Check the continuity between A/F sensor 1 harness connector and IPDM E/R harness connector.
A/F sensor 1 | IPDM E/R | Continuity |
Connector | Terminal | Connector | Terminal |
F18 | 4 | F35 | 75 | Existed |
Is the inspection result normal?
Perform the trouble diagnosis for power supply circuit. Repair or replace malfunctioning part.
3.CHECK A/F SENSOR 1 HEATER OUTPUT SIGNAL CIRCUIT
4.CHECK A/F SENSOR 1 HEATER
5.REPLACE A/F SENSOR 1
Replace A/F sensor 1. Refer to Removal and Installation.caution | - Discard any A/F sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.
- Before installing new A/F sensor, clean exhaust system threads.
|
: INSPECTION END