Standard and Limit | : Refer to CylinderBlockCylinder Block. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
note | Piston is available together with piston pin as assembly. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
: OK | |
: NG |
: Bend | |
: Torsion | |
(C) | : Suitable tool |
Limit | : Refer to CylinderBlockCylinder Block. |
: Connecting rod | |
(A) | : Measuring direction of inner diameter |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
caution | Do not allow gasket flakes to enter engine oil or engine coolant passages. |
Limit | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
note | Ladder assembly cannot be replaced as a single unit because it is machined together with cylinder block. |
F | : 10 mm (0.39 in) |
G | : 75 mm (2.95 in) |
H | : 140 mm (5.51 in) |
note | When determining cylinder bore grade, measure the cylinder bore at (B) position. |
Standard: | |
Cylinder bore inner diameter | |
: Refer to CylinderBlockCylinder Block. | |
Limit: | |
Out-of-round [Difference between (A) and (B)] | |
Taper [Difference between (C) and (D)] | |
: Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Standard | : Refer to CylinderBlockCylinder Block. |
Limit: | ||
Out-of-round [Difference between (A) and (B)] | ||
Taper [Difference between (X) and (Y)] | ||
: Refer to CylinderBlockCylinder Block. |
Limit | : Refer to CylinderBlockCylinder Block. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
caution | Do not rotate crankshaft. |
note | The procedure when the measured value exceeds the limit is same as that described in the “Method by Calculation”. |
Standard and Limit | : Refer to CylinderBlockCylinder Block. |
caution | Do not rotate crankshaft. |
note | The procedure when measured value exceeds the limit is same as that described in “Method by Calculation”. |
A | : Example |
Standard: There must be crush height. |
A | : Example |
Standard: There must be crush height. |
A | : 30 mm (1.18 in) |
B | : 20 mm (0.79 in) |
E | : 10 mm (0.39 in) |
Limit [(D) - (C)] | : 0.13 mm (0.0051 in) |