[Previous][Next]
On Board Diagnosis Function
 
 
ON BOARD DIAGNOSIS ITEM
The following meter functions can be checked during combination meter self-diagnosis mode:
  • Pointer sweep of speedometer, tachometer and gauges.
  • Illumination of color patterns for meter displays.
  • Illumination of all lamps/LEDs that are controlled by the combination meter (regardless of switch status).
  • Error code
 
 
METHOD OF STARTING
 
 
How to Initiate Self-Diagnosis Mode
  1. Turn ignition switch OFF.
  2. While pressing the control switch , turn ignition switch ON.
  3. Keep pressing the control switch for 1 seconds or more.
  4. Press the control switch at least 3 times. (Within 7 seconds after the ignition switch is turned ON.)
  5. “Work instruction code” is indicated in the top portion of information display and self-diagnosis is started.
    noteWhen on-board diagnosis does not start, check the following items and replace combination meter if the check results are normal.
  6. The mode switches in the order shown below each time the control switch is pressed.
    note
    • If the control switch is not operated for 20 seconds or more, the self-diagnosis mode is automatically cancelled.
    • The self-diagnosis mode is cancelled by turning the key switch OFF.
    • The self-diagnosis mode is cancelled by engine speed 170 rpm or more.
Test orderTest itemDescription
1Work instruction codeThis item is displayed, but not used.
2Spare parts No.
Soft ware code
Flash rom No.
3EEPROM code
4Hardware code
5PCB code
6Circuit checkThe pointer of the following items moves from 0 to MAX then from MAX to 0.
  • Speedometer
  • Tachometer
  • Engine coolant temperature gauge
  • Fuel gauge
noteIf any one of the pointers does not sweep, replace combination meter.
7 – 10Color checkPerforms the color check of the information display.
11Error code*Displays the error code of the following items.
  • Speedometer
  • Tachometer
  • Engine coolant temperature gauge
  • Fuel gauge
  • Steering switch
12Warning/indicator light checkAll warning/indicator light illuminate.
noteSecurity indicator light are not illuminate.
noteWhen the control switch is pressed during the indication of "Test order 12", test item returns to "Test order 2".
*: Error Code
ItemCodeDescriptionAction to take/Reference
Speedometer0Normal
1A vehicle speed signal can not be received from ECM.Perform “Self Diagnostic Result” of “ECM.”
Refer to DTC Index.
2A vehicle speed signal received from ECM is abnormal. (FFFFh)
Tachometer0Normal
1An engine speed signal cannot be received from ECM.Perform “Self Diagnostic Result” of “ECM.”
Refer to DTC Index.
Fuel gauge0Normal
1Fuel gauge circuit is short.Refer to Component Function Check.
2Fuel gauge circuit is open.
Engine coolant temperature gauge0Normal
1An engine coolant temperature signal cannot be received from ECM.Perform “Self Diagnostic Result” of “ECM.”
Refer to DTC Index.
  • Illumination control switch
  • Steering switch (control switch)
0Normal
1When judging that the illumination control switch signal circuit is short-circuited for 5 minutes or more.Refer to Component Function Check.
2When judging that the steering switch (control switch) signal circuit is short-circuited for 5 minutes or more.Refer to Component Function Check.
3When judging that the illumination control switch and steering switch (control switch) signal circuit are short-circuited for 5 minutes or more.Refer to Component Function Check and Component Function Check.
0Displays “0” constantly.
0Displays “0” constantly.
0Displays “0” constantly.