[Previous][Next]
Component Function Check
1.CHECK COMBINATION METER INPUT SIGNAL
  1. Turn ignition switch ON.
  2. Measure voltage between the following terminals of the combination meter.
    Combination meterConditionVoltage
    (Approx.)
    ConnectorTerminals
    (+)(−)
    M762532When illumination control switch (+) is pressed0 V
    Other than the above5.0 V
    31When illumination control switch (−) is pressed0 V
    Other than the above5.0 V
Is the inspection result normal?
INSPECTION END
Refer to Diagnosis Procedure.