[Previous][Next]
Removal and Installation
 
 
REMOVAL
cautionNever damage front door glass and front door panel.
 
 
1. Remove front door finisher. Refer to Removal and Installation.
2. Remove rear side of sealing screen.
(1) Disconnect door harness connector .
(2) Cut butyl-tape inside of front door sealing screen by using cutter knife, and then remove rear side of sealing screen.
cautionFor reuse front door sealing screen, cut the butyl-tape by using a cutter knife (A) that to remain both front door panel and sealing screen .
3. Reconnect power window main switch connector.
4. Remove door corner cover and inside seal. Refer to Removal and Installation.
5. Operate power window main switch to raise or lower front door glass until front door glass mounting bolts can bee seen, and then remove front door glass mounting bolts.
6. Hold securely front door glass, and then remove it according to numerical order 1→3 indicated by arrows as shown in figure.
cautionNever damage front door glass, front door glass run and front door panel.
 
 
INSTALLATION
Note the following item, and then install in the reverse order of removal.
caution
  • Tighten front door glass mounting bolts to the specified torque. Refer to Exploded View.
  • After installing front door glass, perform the inspection and adjustment. Refer to Inspection and AdjustmentInspection and Adjustment.