[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Fully close front door glass.
2. Remove front door finisher. Refer to Removal and Installation.
3. Remove front door sealing screen. Refer to Removal and Installation.
4. Disengage front door outside handle harness connector , and then disengage front door outside handle harness connector fixing clip (if equipped).
: Vehicle front
5. Remove key rod from key rod holder according to the numerical order 1→2 indicated by arrows as shown in figure (if equipped).
: Vehicle front
6. Remove door side grommet , and then loosen TORX bolt from grommet hole.
7. Remove front door outside handle escutcheon from front door panel.
8. Slide front door outside handle grip toward rear of vehicle and remove it according to the numerical order 1→2 indicated by arrows as shown in figure.
9. Disengage front gasket and rear gasket fixing pawls, and then remove front gasket and rear gasket.
: Pawl
10. Slide front door outside handle bracket toward rear of vehicle and remove it.
: Vehicle front
11. Disengage front door outside handle cable from front door outside handle cable clip.
12. Disconnect front door outside handle cable from front door outside handle bracket according to the numerical order 1→2 indicated by arrows as shown in figure.
 
 
INSTALLATION
Note the following items, and then install in the reverse order of removal.
caution
  • When connecting front door outside handle cable to front door outside handle bracket, check that front door outside handle cable is properly engaged with front door outside handle bracket.
  • When installing front door outside handle bracket, be careful that front door outside handle cable is routed normally.
  • When engage front door outside handle cable to front door outside handle cable clip , make front door outside handle cable clip as shown in figure.
    : Vehicle front
  • When installing front door outside handle grip, be careful that front door outside handle grip harness and body side harness are routed normally (with request switch models).
  • When installing key rod, rotate key rod holder until a click is felt.
  • After installation, check door lock. Refer to Inspection.