[Previous][Next]
Removal and Installation
 
 
REMOVAL
  1. Remove hood lock release handle from hood lock release assembly.
  2. Remove dash side finisher LH. Refer to Removal and Installation.
  3. Remove hood lock release assembly mounting bolt.
  4. Disengage hood lock release cable from hood lock release assembly according to numerical order 1→2 indicated by arrows as shown in figure.
  5. Remove hood lock release assembly.
 
 
INSTALLATION
Note the following items, and then install in the reverse order of removal.
caution
  • Never reuse hood lock release handle. Always replace it with a new one when it is removed.
  • After installation, perform hood lock control inspection. Refer to Inspection.
  • After installation, check hood open/close operation.