Inspection

note	If the hood lock release cable is bent or deformed, replace it.

1. Check that operating force of hood lock release handle shall be less than 49 N (5.0 kg, 11.0 lb).

2. Check that primary latch

is securely engaged with striker

when hood assembly is closed [free-fall from approximately 200mm (7.874 in) height].

: Vehicle front

3. While operating the hood opener carefully, check that the front end of the hood is lifted by approximately 20 mm (0.787 in) (C). Also, check that the hood opener returns to the original position.

Striker

Primary latch

: Vehicle front

4. Check that secondary latch

is properly engaged with striker

[8.1mm (0.319 in) MIN] (C).

: Vehicle front

5. Check that secondary latch is securely engaged with striker from dead load of hood assembly.

6. Check the hood lock lubrication condition. If necessary, apply body grease to hood lock.

: Body grease