[Previous][Next]
Removal and Installation
cautionNever damage the body panel.
 
 
REMOVAL
 
 
1. Remove center pillar lower garnish. Refer to Removal and Installation.
2. Remove front seat belt anchor. Refer to Removal and Installation.
3. Apply protective tape (A) on f center pillar upper garnish to protect it from damage.
4. Disengage bolt cap fixing pawls using a remover tool (A), and then remove bolt cap.
: Pawl
5. Remove center pillar upper garnish mounting bolt.
6. Disengage center pillar upper garnish lower side fixing clip, and then remove center pillar upper garnish.
: Clip
 
 
INSTALLATION
Note the following item, and then install in the reverse order of removal.
caution
  • Visually check clip for deformation and damage during installation. Replace with new ones if necessary.
  • Check in advance that clip is accurately aligned with the hole on body panel, and then install by pressing in.