[Previous][Next]
Removal and Installation
cautionNever damage the body panel.
 
 
REMOVAL
 
 
1. Fully open front door and rear door.
2. Remove front body side welt and rear body side welt. Refer to Removal and Installation.
3. Disengage seat belt cover fixing pawls, and then remove seat belt cover.
: Pawl
4. Disengage center pillar lower garnish upper side fixing pawls.
: Pawl
5. Disengage center pillar lower garnish fixing clips, and then remove center pillar lower garnish.
: Clip
 
 
INSTALLATION
Note the following items, and then install in the reverse order of removal.
caution
  • Visually check clips for deformation and damage during installation. Replace with new ones if necessary.
  • Check in advance that clips and pawls are accurately aligned with the portions on center pillar upper garnish and body panel, and then install by pressing in.